This MSDS covers part numbers 60012CL for
Tap Magic Formula 2 "Eco-Oil" Aerosol Cutting Fluid.
Click for a printable PDF.
MATERIAL SAFETY DATA SHEET
U.S. DEPARTMENT OF LABOR, OCCUPATIONAL SAFETY AND HEALTH ADMINISTRATION, HAZARD
COMMUNICATION STANDARD, 29 CFR 1910.1200
The Steco Corporation
2330 Cantrell Road
P.O. Box 2238
Little Rock, AR 72203
Emergency Response: (800) 255-3924
Information: (800) 643-8026
Fax #: (501) 374-4278
Date Reviewed: March 1, 2006
Current Date: September 22, 2008
TRADE NAME: TAP MAGIC Formula 2 "Eco-Oil" Aerosol Cutting Fluid
CHEMICAL NAME & SYNONYMS: Mixed Triglycerides
DOT SHIPPING NAME: Aerosol, ORM-D
HMIS/NFPA CODE: Health 0; Fire 1; Reactivity 0
MANUFACTURING CODE NO.: 8358
COMMODITY CODE NO.: 332-9150
I. HAZARDOUS COMPONENTS
This product contains no toxic or hazardous ingredients by OSHA criteria;
however, as with any chemical product, exposure to liquids, vpors, mists and
fumes should be minimized.
II. INGREDIENTS
Proprietary Mixture
Carbon Dioxide Propellant: CAS 124-38-9, TLV 5000, <3%
III. PHYSICAL DATA
BOILING RANGE, (760 mm, Mercury): 610 degrees F
SPECIFIC GRAVITY (Water =1), lbs/gal.: .92
VAPOR PRESSURE (mm of Mercury) @ 68 degrees F: N/D
VAPOR DENSITY (Air = 1): N/D
SOLUBILITY IN WATER, % by weight: Soluble
EVAPORATION RATE (Water = 1): N/A
% VOLATILE BY VOLUME @ 75 degrees F: N/D
APPEARANCE: Amber color
ODOR: Mild
pH: N/D
IV. FIRE & EXPLOSION DATA
LOWER FLAMMABLE LIMIT IN AIR (% BY VOLUME): N/D
UPPER FLAMMABLE LIMIT IN AIR (% BY VOLUME): N/D
FLASH POINT, PMCC: 610 degrees F
AUTOIGNITION TEMPERATURE: N/D
EXTINGUISHING MEDIA: Foam, carbon dioxide, dry chemical, water spray.
V. HEALTH HAZARD INFORMATION
ROUTES OF ENTRY: Inhalation or ingestion are the primary methods of possible
entry.
EFFECTS OF ACUTE OVEREXPOSURE:
INHALATION – (Unlikely due to low vapor pressure.) Non expected by this
route in normal use.
INGESTION – None expected by this route in normal use.
EYES – Non expected by this route in normal use.
EFFECTS OF CHRONIC OVEREXPOSURE:
SKIN CONTACT – Prolonged or repeated exposure may cause
slight irritation.
CARCINOGENICITY: Not a carcinogen or suspect carcinogen.
EMERGENCY AND FIRST AID PROCEDURES:
EYE – Flush eyes gently with water for at least 15 minutes. Supportive
treatment is recommended.
SKIN – Wash with mild soap and water. Remove wetted clothing.
INHALATION – Remove to fresh air.
INGESTION – Do not induce vomiting. Call a physician and/or transport
ot emergency medical facility.
.
VI. REACTIVITY DATA
STABILITY – Stable
INCOMPATIBILITY – Avoid contact wiht bleaching agents and oxidizers
which include chlorine, oxygen, permanganates, perchlorates, percarbonates,
peroxides, chromates, hypochlorites, nitric acid and sulfuric acid.
HAZARDOUS DECOMPOSITION – Miscellaneous organic compounds, some possibly
toxic.
VII. DISPOSAL, SPILL OR LEAK PROCEDURES
SPILL OR LEAK PROCEDURES – Contain and dispose of in accordance with
Federal, State and local regulations.
WASTE DISPOSAL METHOD – Material that cannot be used or chemically reprocessed
should be disposed of at an approved facility in accordance with an applicable
regulations under the Resource Conservation and Recovery Act. Dispose of material
in accordance with all Federal, State and local regulations. Avoid discharge
to sewers or waterways. Product is biodegradable.
VIII . SPECIAL PRECAUTIONS
Wear protective equipment when handling. Use only with adequate ventilation.
Do not breath vapor or mist. Do not get in eyes, on skin or clothing. Wash
thoroughly after handling.
IX. ADDITIONAL INFORMATION
Tap Magic Eco-Oil does not contain 1,1,1 trichloroethane or any ozone-depleting
substances. Eco-Oil does not contain chlorine, phosphorous, active sulfur,
nitrates, nitrite derivatives, amines, polynucleur aromatic compounds either
as ingredients or trace contaminants.
Tap Magic Eco-Oil does not contain any chemical compound listed on the SARA list of 'Extremely Hazardous Chemicals,' and is in compliance with all of the regulations of the TSCA at the time of shipment. Shelf life is indefinite at ambient temperatures and if left in original containers.
Caution: Any cutting fluid can be "overworked" or
"overheated," causing it to break down. This overuse is identified
by the sight of or strong odor of vapors or fumes not normally present. The
effects of these vapors or fumes on human health have not been fully determined.
After use of this produce, clean and lubricate metal surfaces to avoid staining
and/or corrossion.
___________________________________________________________________________________________________________
Prepared by: Asa L. Morton, Chief Chemist, American Interplex Corp, Little
Rock, AR 72204 (501) 224-5060
| Tap
Magic Xtra-Foamy |
  |
|
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||