This MSDS covers part numbers 30004R, 30016R, 30128R, 30640R,
33840R and 37040R for
Tap Magic ProTap Cutting Fluid. Click
for a printable PDF.
MATERIAL SAFETY DATA SHEET
U.S. DEPARTMENT OF LABOR, OCCUPATIONAL SAFETY AND HEALTH ADMINISTRATION, HAZARD
COMMUNICATION STANDARD, 29 CFR 1910.1200
The Steco Corporation
2330 Cantrell Road
P.O. Box 2238
Little Rock, AR 72203
Emergency Response: (800) 255-3924
Information: (800) 643-8026
Fax #: (501) 374-4278
Date Reviewed: March 1, 2006
Current Date: September 22, 2008
TRADE NAME: TAP MAGIC PROTAP Cutting Fluid
CHEMICAL NAME & SYNONYMS: Hydrocarbon Mixture
DOT SHIPPING NAME: Not a regulated material
IATA SHIPPING NAME: No hazard label required. No limit on quantity.
HMIS/NFPA CODE: Health 0; Fire 1; Reactivity 0.
MANUFACTURING CODE NO.: 8358
COMMODITY CODE NO.: 332-9150
I. HAZARDOUS INGREDIENTS
This product contains no toxic or hazardous ingredients by OSHA criteria;
however, as with any chemical product, exposure to liquids, vapors, mists
and fumes should be minimized.
II. INGREDIENTS
Aliphatic Organic Acid: CAS# 112-80-1 >75% mixture
Aliphatic Organic Ester: CAS# 112-62-9 <15% mixture
Organic Polyol: CAS# None Assigned <10% mixture
III. PHYSICAL DATA
BOILING RANGE, (760 mm Mercury): 680 to 1000° F
SPECIFIC GRAVITY (Water = 1) (lbs/gal): (0.894) 7.46 lbs/gal
VAPOR PRESSURE (mm of Mercury) @ 75° F: Less Than 1
VAPOR DENSITY (Air = 1): Greater Than 5
SOLUBILITY IN WATER, % by weight: Less Than 1 (Insoluble)
EVAPORATION RATE (Butyl Acetate = 1): Less Than 0.01
% VOLATILE BY VOLUME @ 75° F: Less Than 1
APPEARANCE: Yellow Liquid
ODOR: Pleasant
pH: Nonaqueous
IV. FIRE & EXPLOSION DATA
LOWER FLAMMABLE LIMIT IN AIR (% by Volume): 1.0
UPPER FLAMMABLE LIMIT IN AIR (% by Volume): 15
FLASH POINT, PMCC: 370° F
AUTOIGNITION TEMPERATURE: 685° F
EXTINGUISHING MEDIA: Foam, Carbon Dioxide, Dry Chemical
V. HEALTH HAZARD INFORMATION
ROUTES OF ENTRY: Ingestion is the primary method of possible entry.
EFFECTS OF ACUTE OVEREXPOSURE:
INHALATION – (Unlikely due to low vapor pressure). Mist may cause headache,
nasal, respiratory and eye irritation.
INGESTION – Headache, drowsiness, nausea, fatigue.
EYE – May cause pain and irritation.
EFFECTS OF CHRONIC OVEREXPOSURE:
SKIN CONTACT – Prolonged or repeated exposure may cause irritation.
CARCINOGENICITY: Not a carcinogen or suspect carcinogen.
EMERGENCY AND FIRST AID PROCEDURES:
EYE – Flush eyes gently with water for at least 15 minutes. Supportive
treatment is recommended.
SKIN – Wash with mild soap and water. Remove wetted clothing until dry.
INHALATION – Remove to fresh air.
INGESTION – Do not induce vomiting. Call a physician and/or transport
to emergency medical facility.
.
VI. REACTIVITY DATA
Materials such as sawdust or cloth rags which have been wetted with lubricant
may be subject to spontaneous combustion during storage.
VII. DISPOSAL, SPILL OR LEAK PROCEDURES
AQUATIC TOXICITY – Aquatic toxicity is low: Product is not soluble in
water. Biodegradable.
SPILL OR LEAK PROCEDURES – Absorb with inert materials. Remove to out
of doors and incinerate.
WASTE DISPOSAL METHOD – Tap Magic ProTap contains no environmentally
hazardous substances. Small amounts may be incinerated in compli¬ance
with local, state and federal regulations. The recommended method of disposal
for large quantities is recycling by a reclaimer or incineration. "If
inert absorbents are employed in spill containment or cleanup, these absorbents
must be non-biodegradable materials if destined for landfill disposal. Suitable
absorbents include natural minerals (clay), activated charcoal, man-made polymers
(HD polyethylene)."
VIII. SPECIAL PROTECTION INFORMATION
EYE PROTECTION – Standard eye protection should be worn when using this
product.
SKIN PROTECTION – No special protection is needed. However, good personal
hygiene practices should be followed.
RESPIRATORY – If application to which this product is being applied
generates excessive mist or fumes, then appropriate respiratory protective
equipment should be used. No special requirements under ordinary condition
and use and proper ventilation of work area.
VENTILATION – No special requirements under ordinary conditions of use
and with adequate ventilation.
IX. SPECIAL PRECAUTIONS
Product is ignitable, keep away from open flames. Do not expose to ignition
sources. Storage life is indefinite if protected from heat and moisture. Do
not store with strong oxidizers such as nitrates or perchlorates or oxygen
under pressure. May cause swelling of some plastics and synthetic rubbers.
X. ADDITIONAL INFORMATION
Tap Magic ProTap DOES NOT CONTAIN 1,1,1-trichloroethane or any ozone depleting
substances. PROTAP does not contain chlorine, phosphorous, active sulfur,
nitrates, nitrite derivatives, amines, polynuclear aromatic compounds either
as ingredients or trace contaminants. Tap Magic ProTap does not contain any
chemical compound listed on the SARA list of 'Extremely Hazardous Chemicals',
and is in compliance with all of the requirements of the TSCA at the time
of shipment.
Caution: Any cutting fluid can be "overworked" or "overheated",
causing it to break down. This overuse is identified by the sight of or strong
odor of vapors or fumes not normally present. The effects of these vapors
or fumes on human health have not been fully deter¬mined. After use of
this product, clean and lubricate metal surfaces to avoid staining and/or
corrosion.
___________________________________________________________________________________________________________
By : Asa L. Morton, Chief Chemist, American Interplex Corporation, Little
Rock, AR 72204, (501) 224-5060
| Tap
Magic Xtra-Foamy |
  |
|
|
||
|
||
|
||
|
||
|
||
|
||
|
||
|
||